Hello Guys, Today I am going to tell you that how can you change your IP address in just few steps.
Note - This Only Changes Your Dynamic IP Address, Not Your ISP/IP Address. If You Plan to Hack A
Website With This Trick Be Extremely Careful, Because If They Try A Little, They Can Trace It Back..
So Let's Start..
Step 1- Click on "Start" In The Bottom Left Hand Corner Of Screen...
Step 2 - Click On "Run"..
Step 3-Type In "Command" And Hit Ok..
Step 4 - Type "ipconfig/Release" Just Like That, And Hit "Enter"..
Step 5 - Type "Exit" and Leave The Prompt..
Step 6 - Right click on "Network Places" Or "My Network Places" On Your Desktop...
Step 7 - Click On "Properties"
Step 8 - Right click on "Local Area Connection" and click "properties"
Step 9 - Double-click on the Internet Protocol (TCP/IP)" from the list under the "General" tab
Step 10 Click on "Use the following IP address" under the "General" tab
Step 11 Create an IP address (I just type 1 and 2 until I fill the area up)
Step 12 - Press "Tab" and it should automatically fill in the "Subnet Mask" section with default
numbers.
Step 13 - Hit the "Ok" button here
Step 14 - Hit the "Ok" button again
You should now be back to the "Local Area Connection" screen.
Step 15 Right-click back on "Local Area Connection" and go to properties again.
Step 16 - Go back to the "TCP/IP" settings
Step 17 - This time, select "Obtain an IP address automatically" tongue.gif
Step 18 Hit "OK"
Note - This Only Changes Your Dynamic IP Address, Not Your ISP/IP Address. If You Plan to Hack A
Website With This Trick Be Extremely Careful, Because If They Try A Little, They Can Trace It Back..
So Let's Start..
Step 1- Click on "Start" In The Bottom Left Hand Corner Of Screen...
Step 2 - Click On "Run"..
Step 3-Type In "Command" And Hit Ok..
Step 4 - Type "ipconfig/Release" Just Like That, And Hit "Enter"..
Step 5 - Type "Exit" and Leave The Prompt..
Step 6 - Right click on "Network Places" Or "My Network Places" On Your Desktop...
Step 7 - Click On "Properties"
Step 8 - Right click on "Local Area Connection" and click "properties"
Step 9 - Double-click on the Internet Protocol (TCP/IP)" from the list under the "General" tab
Step 10 Click on "Use the following IP address" under the "General" tab
Step 11 Create an IP address (I just type 1 and 2 until I fill the area up)
Step 12 - Press "Tab" and it should automatically fill in the "Subnet Mask" section with default
numbers.
Step 13 - Hit the "Ok" button here
Step 14 - Hit the "Ok" button again
You should now be back to the "Local Area Connection" screen.
Step 15 Right-click back on "Local Area Connection" and go to properties again.
Step 16 - Go back to the "TCP/IP" settings
Step 17 - This time, select "Obtain an IP address automatically" tongue.gif
Step 18 Hit "OK"
Comments
Post a Comment